Support on o2c files (Objects 2 See) and o2c Interactive!
#49843 by Nick Pyner
Fri Aug 20, 2010 8:30 pm
After a bit of tearing of hair over at Greg's last night on the abovementioned picture mount problem, I am concluding that o2c will not work with a single polygon.

Is this an X3 bug, or has it always been the case?

A single slab is OK. Maybe o2c refuses to accept a poly because there is a dimension missing and it isn't a 3D model.(?)
#49849 by Rick Oswalt
Sat Aug 21, 2010 4:16 pm
It seems, if I understand your need, if you draw a vertical polygon any length then add 1 millimeter polygon on the end it will appear in O2C
#49852 by Nick Pyner
Sat Aug 21, 2010 8:11 pm
OK. Two polys.
Thanks

Who is online

Users browsing this forum: No registered users and 1 guest

About DataCAD Forum

The DataCAD Forum is a FREE online community we provide to enhance your experience with DataCAD.

We hope you'll visit often to get answers, share ideas, and interact with other DataCAD users around the world.

DataCAD

Software for AEC Professionals Since 1984