Support on o2c files (Objects 2 See) and o2c Interactive!
#57381 by dannac
Mon May 21, 2012 3:04 pm
In the render setup, I applied a bitmap image as a texture.
I can also adjust the scale for the quantity of circles that would show in the image.

Is there a render setting to adjust the location, vertical & horizontal ?

Trying to get one circle centered in frame.

#57429 by MtnArch
Fri May 25, 2012 11:33 am
Try posting it over on the GoogleGroups Dbug forum - there's been a very lively discussion regarding O2C and you may get your answer there. Here's a link for it:
#57439 by jimgoodman
Sat May 26, 2012 8:13 am
1. On the main Windows type menu bar, go to View, Rendering, Texture Origin.
2. Select the polygon in question with the "Set" option selected/highlighted. There are a number of options available for setting the texture origin. My favorite is 3d cursor which works well in a Parallel View (Elevation or Isometric).
3. Snap to a point on the polygon - in your case it will probably be the center of the polygon in question.
4. Exit out.

This function is only available from the main Windows type menus. Because it's a bit hard to find and get to, I created a custom button on my 3d toolbar to access this function.
[Texture Origin]
Hint=Set Texture Origin
Last edited by jimgoodman on Sat May 26, 2012 8:22 am, edited 1 time in total.
#58888 by dennisnorton
Wed Dec 19, 2012 2:16 pm
I have attempted to add the pull down, but my dcadwin.mnu file looks nothing like that in the example... Perhaps I am looking at the wrong file for adding shortcuts?
DcadWin_mnu File.jpg
Portion of the DcadWin.mnu file
DcadWin_mnu File.jpg (173.6 KiB) Viewed 31205 times
#58893 by Roger D
Wed Dec 19, 2012 4:48 pm
Very true. For me it's not an issue, but new users can really be lost. The manual should really have a major rewrite for the new users, but I personally want improvements to the program.
I have a friend who has been learning the program, and I have answered many questions that should be in the manual.

Who is online

Users browsing this forum: No registered users and 1 guest

About DataCAD Forum

The DataCAD Forum is a FREE online community we provide to enhance your experience with DataCAD.

We hope you'll visit often to get answers, share ideas, and interact with other DataCAD users around the world.


Software for Architects Since 1984