Page 1 of 1
O2c drag and drop
Posted:
Fri Mar 07, 2014 12:07 pmby damian
I just dragged and dropped a jpeg from the desktop into O2C screen area .... not done before. I was not aware of the fact that you can change O2C materials via "drag and drop" with jpeg or bitmap images. Cool.. Too bad that you can not manage but it is nice to get a quick idea of the materials you want to use.
Re: O2c drag and drop
Posted:
Fri Mar 07, 2014 1:43 pmby joshhuggins
Which O2C screen did you do this in?
Re: O2c drag and drop
Posted:
Fri Mar 07, 2014 2:10 pmby damian
It works just launching O2C from DataCAD
Re: O2c drag and drop
Posted:
Fri Mar 07, 2014 2:28 pmby joshhuggins
Hmmm I can't seem to do this.
Re: O2c drag and drop
Posted:
Fri Mar 07, 2014 2:50 pmby damian
does not work with PNG, but only jpeg or bmp
Re: O2c drag and drop
Posted:
Fri Mar 07, 2014 5:13 pmby joshhuggins
Was trying a jpg. Can anyone else get this to work? Sounds like it would be very handy.
Re: O2c drag and drop
Posted:
Fri Mar 07, 2014 5:57 pmby David A. Giesselman
Works here.
Re: O2c drag and drop
Posted:
Fri Mar 07, 2014 7:48 pmby joshhuggins
So if I launch an O2C object from Windows into the vanilla O2C viewer I can get it to work on non-reflective or transparent surfaces, which is really cool! Just doesn't work when I launch objects form within Datacad to the Datacad enhanced Object Viewer. My O2C player version is 1.9.9.149.
Re: O2c drag and drop
Posted:
Sat Mar 08, 2014 5:18 amby damian
Yes, only works on surfaces that are not transparent. But it is however very handy.
I think my version of O2C is the same as yours and works fine when I launch from within DataCAD
Someone else can tell us something about this?