Page 1 of 1

No model in o2c

PostPosted: Fri Nov 07, 2014 5:49 pm
by jtheat
I've created a simple 3d model DC15... launch viewer... and the screens blank. ?? I opened up some past models, and all is fine. I even go to plan view, etc... all blank screen. Thoughts?

Re: No model in o2c

PostPosted: Fri Nov 07, 2014 6:06 pm
by jimgoodman
Try hitting the home key.

You can also right-click in the O2C window and make sure that Scroll Bars is unchecked. You should see buttons in the lower right hand corner of the screen. Hit the "a" button (extents).

Re: No model in o2c

PostPosted: Fri Nov 07, 2014 6:16 pm
by joshhuggins
If you view the model in iso view and do a zoom extents does it stay within reason on the screen?

Re: No model in o2c

PostPosted: Fri Nov 07, 2014 6:23 pm
by jtheat
In iso view, not in o2c, it comes up fine. In o2c, nothing but black screen.
I even pasted it into another drawing and it works fine there, too.
I must have something weird setup somewhere in the drawing.

Re: No model in o2c

PostPosted: Fri Nov 07, 2014 6:25 pm
by jtheat
Checked the scroll bars... they are off...

Re: No model in o2c

PostPosted: Fri Nov 07, 2014 6:30 pm
by jimgoodman
jtheat wrote:Checked the scroll bars... they are off...

Do you see the R, - a and + in the lower right hand corner? If not, toggle the scroll bars so you see them.

Also, try the home key when in the O2C window and see if the model doesn't come in.