Greetings, Its been a while....(I posted this in Ver22 also)
Just upgraded from DCX3 to DC22 and am frustrated with the operation of o2c.
I can get it to run the FIRST TIME on both simple and VERY Complex Models (in grey tones) but it crashes EVERY TIME when opening the second time regardless of the simplicity of the model! (ie a simple cube and sphere)
This is a production killer!
I'm sure it's a "setup thing" from my end but I'll be darned if I can figure out why this would be happening?
Any thoughts appreciated.
DKS
PS - I also tried to open several o2c models produced earlier directly and these too crash o2c as a stand alone - SO FRUSTRATING!
Just upgraded from DCX3 to DC22 and am frustrated with the operation of o2c.
I can get it to run the FIRST TIME on both simple and VERY Complex Models (in grey tones) but it crashes EVERY TIME when opening the second time regardless of the simplicity of the model! (ie a simple cube and sphere)
This is a production killer!
I'm sure it's a "setup thing" from my end but I'll be darned if I can figure out why this would be happening?
Any thoughts appreciated.
DKS
PS - I also tried to open several o2c models produced earlier directly and these too crash o2c as a stand alone - SO FRUSTRATING!