Page 1 of 1
Viewpoint
Posted:
Mon Jan 08, 2007 11:18 amby DBrennfoerder
Do any of you have a clever trick to establish viewpoint and view angle? When I F2 to walkthrough, I pick an elevation view, then set "perspective" then enter the model. At some point, I want to increase the view angle to 90 degrees or so to approximate a very wide angle lens, but that blasts me right through the model. I wish I could change view angle without changing viewpoint.
Eye Point / Focal Point
Posted:
Mon Jan 08, 2007 11:36 amby Mark F. Madura
Hello Dwight:
Unfortunately, I don't know of any way to avoid this. I usually try to widen the view angle before walking through the model.
MFM
Posted:
Mon Feb 19, 2007 8:23 amby peter korzaan
Hmmm.. just a beginner... but wondered if you have tried right clicking when your in the walk around mode, gives you glasses. It allows you to look up, down, left right without blowing out of the model. Not 90 degrees but gives you eyes.. control to see the interior.