forum.datacad.com

Hi,
I have problems with origin point in o2c. The model created in Datacad around 0,0,0 point ends up in o2c somwhere off the 0,0,0 point of o2c space - that causes model (after command "show all" in o2c) to spin off the screen when rotated. It seems that 0,0,0 coordinates of Datacad are not the same as 0,0,0 coordinates of o2c. Any suggestions how to fix it?

The lights in the DataCAD Shader routine are polygons which are included in the model but are invisible. Go to 3dMenus, then Shader and turn off all lights. LtName1 is on by default. This will put your model back on axis.

Also see this thread on the new forum.

https://www.datacad.com/bbs/viewtopic.php?t=39

Thanks Daniel, I will try that.