Out of the box there are hatches with stars, squares, etc, but none of varying size holes on a 60* grid. Does this animal exist and is it available? I would be most thankful.
Stephen
Stephen
Hatch patterns have to have repeats, in X and Y directionsThe pattern would need to represent an area that could be repeated in X, Y such as that shown in the red rectangle below: Edit: this is incorrect. Each inividual line in the hatch pattern can define it's own repitition - dh .
circles as part of a pattern is tough to do.Hatches are defined using lines (place pen, pen down, move in a straight line to a new position, pen up etc.) so the circles would need to be drawn using straight segments. If the hatch is not going to be shown at a large scale then 36 segments would probably be adequate? Edit: hmmm - I might have been thinking of something else when I wrote this - it is not exactly how the hatch is defined (see comments from MFM towards the end of this thread) - dh.
The hatch pattern definition is difficult to visualize:
[Header]
Scale=1
Angle=0
Display Scale=7
Segments=9
[Segments]
001=0,0, 0, 16,0, 32,55.425625842204073392878282928188, 0,-32,0,-32
002=0,0, 0, 15.0350819325745,5.4723222932107, 32,55.425625842204073392878282928188, 0,-33.9298361348509,0,-30.0701638651491
003=0,0, 0, 12.2567110899036,10.2846017549846, 32,55.425625842204073392878282928188, 0,-39.4865778201927,0,-24.5134221798073
004=0,0, 0, 8,13.856406460551, 32,55.425625842204073392878282928188, 0,-48,0,-16
005=0,0, 0, 2.77837084267089,15.7569240481953, 32,55.425625842204073392878282928188, 0,-58.4432583146582,0,-5.55674168534178
006=0,0, 0, 15.0350819325745,-5.4723222932107, 32,55.425625842204073392878282928188, 0,-33.9298361348509,0,-30.0701638651491
007=0,0, 0, 12.2567110899036,-10.2846017549846, 32,55.425625842204073392878282928188, 0,-39.4865778201927,0,-24.5134221798073
008=0,0, 0, 8,-13.856406460551, 32,55.425625842204073392878282928188, 0,-48,0,-16
009=0,0, 0, 2.77837084267089,-15.7569240481953, 32,55.425625842204073392878282928188, 0,-58.4432583146582,0,-5.55674168534178
could one do a similar effect using the existing circle hatch, but do at a 45° or 60° angle?
Users browsing this forum: No registered users and 59 guests