To all,
Just had an open file error message:-
Events leading up to this were,
1) manual save of open DCX3 file,
2) then minimise DC to task bar,
3) two pdf files open on task bar from previous,
4) open up SketchUp layout Ver 7 to do some editing, old jpeg image not shown in part of my layout, tried to re-load this, then SUL crashed.
5) I then noticed DC had a duplicate tags on the task bar, both now non responsive, so closed these down.
6) tried to open up my DC file again, however this error message came up:-
"unable to open file decompression error 106"
As I did a manual save, I was able to rename the backup file & continue on with my work,
but would like to find out if this is a known problem. i.e. should I close DC before I do any work with SU or SUL.
Over & out,
Clayton Taylor,
Ps. I upgraded to the latest version of DCX3 a few weeks ago, & have not had any more pring woes. Re previous forum message.
Just had an open file error message:-
Events leading up to this were,
1) manual save of open DCX3 file,
2) then minimise DC to task bar,
3) two pdf files open on task bar from previous,
4) open up SketchUp layout Ver 7 to do some editing, old jpeg image not shown in part of my layout, tried to re-load this, then SUL crashed.
5) I then noticed DC had a duplicate tags on the task bar, both now non responsive, so closed these down.
6) tried to open up my DC file again, however this error message came up:-
"unable to open file decompression error 106"
As I did a manual save, I was able to rename the backup file & continue on with my work,
but would like to find out if this is a known problem. i.e. should I close DC before I do any work with SU or SUL.
Over & out,
Clayton Taylor,
Ps. I upgraded to the latest version of DCX3 a few weeks ago, & have not had any more pring woes. Re previous forum message.
Trotman & Taylor Architectural Consultants U.K.
