Those gremlins are back...I've had a series of unusual wall cleanups and note in all cases even though cap=on from the start, clean=off but after 2-line trimming walls, clean switched to being on. It looks like the active clean=on causes the walls to do odd things from time to time.
Will send a file to techsupport.
Will send a file to techsupport.
DataCAD user since v4!
Regards
Mark Bell
Principal
ATELIER MARK BELL
Australia
https://www.ateliermarkbell.com
Regards
Mark Bell
Principal
ATELIER MARK BELL
Australia
https://www.ateliermarkbell.com