when are we going to get the ability to enter xclips by fence, this is of critical importance for making xrefs usable.
Hello Paul & welcome,
This has been on the "official" wish list for a while now. (BTW, you can post your ideas in the Wish List section on this forum, or email them to WishList@DataCAD.com)
Here's a workaround that can work for an 'L' shaped X-Clip Cube, or any other shape for that matter:
Insert two (or more) XRef's -- do one first and X-Clip it for one "leg" of the 'L' and then insert another copy of the same XRef (on maybe another layer?) and the X-Clip it for the other "leg". If you place them both at Absolute Zero, or snap to the same insertion point to align them -- and voila!