Hi Alan,
I'm sorry that you did not get the mailing (yet?). Here's the agenda:
REMINDER: TOMORROW (WEDNESDAY)
DataCAD Boston Users Group -- DBUG July Meeting Agenda
Date: Wednesday, July 27, 2005
Time: 6:00 pm. - 9ish
Location: Reeves Design Associates
215 Boston Post Road
in Allied Consulting Engineering's building, 2nd floor
Sudbury, MA 01776
(directions below)
Pizza for $5 Donation, Complimentary Beer, Wine & soft drinks.
Please RSVP to
neil.blanchard@verizon.net
or call (nine seven eight) 443-4966 Ext. 1
Gathering, Refreshments and general schmoozing
Introductions & Announcements
Basic Lesson: The Basics of Computer Hardware What's this bit?
This will be a hands on show & tell: what is all this stuff inside my
computer case?
by Neil Blanchard
Intermediate Lesson: Our Computers; Upgrade or Replace? Build or Buy?
The dilemma we all face, sooner or later... Things to consider, what to
look for in a new computer. Where do I start, if I want to build my new
machine?
by Neil Blanchard
Advanced lesson: Further Into XRef's: Circular, Nesting, Highlighting,
X-Clips -- The dilemma we all face, sooner or later...
Why draw
anything more than once?
by Neil Blanchard
Directions to Reeves Design Associates:
RDA is in the Allied Consulting Engineering Services building, behind
Patti Bros. Lighting. There is a large black & gold sign w/ "215" in a
gold-outlined ellipse at the entrance to the parking lot.
Drive West from Rt. 128/95 on Route 20 (aka Boston Post Road) just past
Landham Rd. and the gas station, turn left into the parking lot
Drive East from Rt. 495 on Route 20 (aka Boston Post Road) through Marlborough, and into Sudbury just after the Congregation B'nai Torah temple, turn right into the parking lot.
From the Mass Pike, Exit 13, drive east on Rt. 30 to 1st light, go left
(north) onto Speen St., at 2nd light go right onto Old Conn. Path, left
onto Hamilton St., at stop sign go left onto School St., then right at
yield sign onto Elm St. Go straight through light (up hill). When Elm
crosses into Sudbury, it becomes Landham Rd. At stop sign, turn left
onto Rt. 20, past gas station, turn left into parking lot.
We are in the middle building; the sign says Allied Consulting
Engineering. Come in the center front door and go upstairs, to the right.
It will be good to meet you!