forum.datacad.com

I've had problems with some door and window openings. When I've erased some doors or windows, the opening is still there (see attachment). Sometimes, not always after I've erased a door or window, there remains a little tick mark and if I try to draw another wall over the previous opening it automatically leaves an opening. I have tried changing "z" heights and sometimes it works but mostly not.
I've had this problem with previous versions not just v. 15.

I had the same problem. Can't remember for sure, but I think it had something to do with the wall layer z settings (or the window and door layer z settings, or both)

do you have another opening on another layer that might be affecting this?

I'm running into this problem again. All Z settings are the same, I think. I'm running the latest version of 17. Any ideas?