Ask questions about DataCAD 20, DataCAD LT 20, or previous versions here.
#60897 by Bob Urbanek
Sun Jun 30, 2013 11:58 am
I have asked this before, but received no replies. Sometimes, when I go back into O2C after making a change in the drawing, The material assignments get all messed up. I have found 2 ways to fix it------just identify each entity that has changed, or close the drawing, and re-open it. Not a major problem, but really annoying. Has anyone else experienced this problem?
Thanks,
Bob

Who is online

Users browsing this forum: No registered users and 42 guests

About DataCAD Forum

The DataCAD Forum is a FREE online community we provide to enhance your experience with DataCAD.

We hope you'll visit often to get answers, share ideas, and interact with other DataCAD users around the world.

DataCAD

Software for Architects Since 1984