Ask questions about DataCAD 20, DataCAD LT 20, or previous versions here.
#63168 by dtsutton
Sun Feb 02, 2014 2:09 pm
Just switched to windows 7 and on Datacad 12. May not be a Windows problem but didn't have this before.

When I hatch it won't display the hatch until I right click out of the command. I'm certain I didn't have to do this before. Is there a setting for this ?

I can see it creates the boundary and I can hatch all over the place, but until I exit (right click) I see nothing.

Thanks,
Dave

Who is online

Users browsing this forum: No registered users and 37 guests

About DataCAD Forum

The DataCAD Forum is a FREE online community we provide to enhance your experience with DataCAD.

We hope you'll visit often to get answers, share ideas, and interact with other DataCAD users around the world.

DataCAD

Software for Architects Since 1984