Ask questions about DataCAD 16, DataCAD LT 16, or previous versions here.
#63295 by Neil Blanchard
Sat Feb 15, 2014 10:12 am

I'm working on a Saturday (which is a good thing!) and I am doing dimensioning and almost every time I did the second side of a wall, it gives me a dim of 0, and then I have to zoom in and snap again to the second face of the wall to get the 3 5/8" dim. Several times it gave me a 4 5/8" "snap" and inch to the right of the point it should have.

Edit: I found the problem: Perpendicular snapping was turned off ...

Who is online

Users browsing this forum: Exabot [Bot], Google [Bot] and 7 guests

About DataCAD Forum

The DataCAD Forum is a FREE online community we provide to enhance your experience with DataCAD.

We hope you'll visit often to get answers, share ideas, and interact with other DataCAD users around the world.


Software for AEC Professionals Since 1984