forum.datacad.com

Hello,
I'm sure this question has come up before, just can't find the answer.
My DataCad 16 Trial Version is hesitating when my Cursor passes over the 'X' Refs, ?
What setting should I adjust so there is No Pause in the Software ?
Driving Me Crazy ,,,
Thanks in advance for your help,

[Ctrl]+[right-click] on the XREF in the drawing area, select "XREF Tools," and then un-check "Dynamic Snapping." This should speed up cursor movement over the XREF. The delay occurs as DataCAD searches for available snapping points over the XREF.

Thanks Mr. Toce,
Although the Menu you mentioned by doing the Cntrl / Right Click did not have your option. It did have a 'S' Clip Disable button. I've only tried it a few minutes but seems to be much better,

Disabling S-Clips means that symbols will no longer use clipping boundaries. It is unrelated to the issue you're reporting.

Make sure that you position your cursor on top of a line in the XREF. Press and hold the [Ctrl] key on the keyboard, and while holding it down, right-click on top of a line in the XREF. You will see the attached context menu.

Got It,
Man, that was absolutely driving me Bonkers ! Wow, been putting up with that for a couple of days.
So glad I asked. Makes me want to thank the Lord !

This used to drive me nuts too.

I found in the Reference Manager box that you could turn dynamic snapping off globally by highlighting all the xrefs in the drawing and then hitting the "OFF" button under Dyn Snap.

All sweet now!

Thanks For All The Help. Glad I Posted.