Ask questions about DataCAD 20, DataCAD LT 20, or previous versions here.
#64991 by GARY247
Thu Oct 09, 2014 3:24 pm
Is there any way to convert 3d lines to 2d so that I can use the clean up functions?
#64993 by Mark Toce
Thu Oct 09, 2014 3:55 pm
The "SubLine" macro, a free download from our Web site, can substitute 2D lines for 3D lines.

http://www.datacad.com/support/down/Subline.zip

Save the file to a folder on your hard drive, and then unzip it. Copy the enclosed "SubLine.dcx" into your DataCAD\Macros\ folder. Access the macro via the "Toolbox" menu button.

Who is online

Users browsing this forum: No registered users and 28 guests

About DataCAD Forum

The DataCAD Forum is a FREE online community we provide to enhance your experience with DataCAD.

We hope you'll visit often to get answers, share ideas, and interact with other DataCAD users around the world.

DataCAD

Software for Architects Since 1984