For some reason, my aec files are not "crunching" when saving. Have I accidentally set something that prohibits the file from being reduced in size?
For example, I am having to split my aec files into numerous files due to load/reload timing... I have a drawing that is 12,487kb with 4 sheets of plots. Another file, one sheet only, that is 3,269kb.
I have tried PAK files, but didn't help. Tried purging symbols, no help...
Any suggestions?
For example, I am having to split my aec files into numerous files due to load/reload timing... I have a drawing that is 12,487kb with 4 sheets of plots. Another file, one sheet only, that is 3,269kb.
I have tried PAK files, but didn't help. Tried purging symbols, no help...
Any suggestions?