CLEAN UP
Posted:
Mon Oct 26, 2015 12:44 pm
by GARY247
Is there any way to change the clean up one line trim function so it stays off unless you click F1(entity) to turn it on? I looked in datacad.ini but did not see anything.
Re: CLEAN UP
Posted:
Mon Oct 26, 2015 12:54 pm
by David A. Giesselman
Look in the
[General] section of the INI file for the following key:
1LineTrim By Entity=TRUE- If present and TRUE, Entity will always be On.
- If present and FALSE, Entity will always be Off.
- If not present, Entity will remember its previous state
Dave