forum.datacad.com

Hi,

I just attempted to use the PSynColors.DCX macro and since it has been a while since I have used it, I tried clicking on the Symbol Browser, and that doesn't work. I thin placed the symbol in my drawing, and when I click on it, the drawing crashes.

So, no go.

Editing all the colors in a symbol is a very good tool to have - any thoughts on doing this? I am using v18.03.00.06 (SE).

It's working fine here Neil, but you may only select symbols from the drawing (as the prompt indicates).

Reboot?

Dave

After a reboot, it now works.

Here's a wish for this macro - it should remember the settings during a given session.

Does it save the edited version to the hard drive automatically? Edit: no, it does not.