forum.datacad.com

Posted: **Thu Jan 05, 2017 4:38 pm**

It doesn't seem that the number of points snap setting works on associative dims - is this correct?

Posted: **Thu Jan 05, 2017 4:40 pm**

That's correct. It could be added if needed.

Dave

Posted: **Fri Jan 06, 2017 9:12 am**

This could be helpful sometimes.

Posted: **Fri Jan 06, 2017 9:29 am**

So, Number of Points along the dimension line itself?

Posted: **Fri Jan 06, 2017 12:30 pm**

David A. Giesselman wrote:So, Number of Points along the dimension line itself?

Yes, but not including the overrun I'd think.

Posted: **Fri Jan 06, 2017 1:41 pm**

Correct - this saves doing the math, in some situations.

Posted: **Fri Jan 06, 2017 1:49 pm**

Done for the next Subscription update.

Dave

Posted: **Fri Jan 06, 2017 2:22 pm**

Until it is done you could just use divisions to put snap points along the dimension line to snap to and it should work the same.

Posted: **Fri Jan 06, 2017 2:41 pm**

Neil Blanchard wrote:Correct - this saves doing the math, in some situations.

And isn't that what we all want, less math? Except Dave, he loves math :lol:

Thanks Dave!

Number of Points Snapping