Ask questions about DataCAD 20, DataCAD LT 20, or previous versions here.
#70609 by gehlen designs
Thu Jan 12, 2017 3:32 pm
I am trying to set up a 4 line 2x6 wall with Dots as the hatch type in the cavity of the 2x6 wall. The dots (hatch) show up between lines 3 and 4 instead of the center of the 2x6 wall wall which are lines 2 &3. I have done this wall type before and had no problem now. When I designate center for the hatch pattern its returns to the wrong cavity which is lines 3 &4 versus line 2&3.
anyone have any ideas what I am doing wrong.
Frank
#70614 by Roger D
Thu Jan 12, 2017 5:20 pm
Are you hitting "apply" after making the change?
Do you change the "inside" setting to not do hatch, then change the "center" setting to do the hatch, hitting apply each time?

Who is online

Users browsing this forum: Google [Bot] and 28 guests

About DataCAD Forum

The DataCAD Forum is a FREE online community we provide to enhance your experience with DataCAD.

We hope you'll visit often to get answers, share ideas, and interact with other DataCAD users around the world.

DataCAD

Software for Architects Since 1984