Hatch in exterior walls
Posted: Thu Jan 12, 2017 3:32 pm
I am trying to set up a 4 line 2x6 wall with Dots as the hatch type in the cavity of the 2x6 wall. The dots (hatch) show up between lines 3 and 4 instead of the center of the 2x6 wall wall which are lines 2 &3. I have done this wall type before and had no problem now. When I designate center for the hatch pattern its returns to the wrong cavity which is lines 3 &4 versus line 2&3.
anyone have any ideas what I am doing wrong.
Frank
anyone have any ideas what I am doing wrong.
Frank