Ask questions about DataCAD 20, DataCAD LT 20, or previous versions here.
#71020 by Roger D
Thu Mar 16, 2017 12:46 pm
1. Hit the point you want at 0,0,0 with the ?, you will see the current location, and move those distances back.
2. Change to Absolute Cartesian (insert key will cycle through) and move the point you want to 0,0.
#71021 by joshhuggins
Thu Mar 16, 2017 12:55 pm
If you have a reference point for 0.0 in your topo, Set your Input method to either Absolute Cartesian or Absolute Polar, turn on all the layers that need to move, and use Move, Snap to your Absolute Zero reference point, then hit your SPACEBAR and then hit ENTER, ENTER. Then CTRL+A should move everything, it it doesn't you will need to do an Area around everything with crossing enabled. That should do it.

Who is online

Users browsing this forum: Google [Bot] and 50 guests

About DataCAD Forum

The DataCAD Forum is a FREE online community we provide to enhance your experience with DataCAD.

We hope you'll visit often to get answers, share ideas, and interact with other DataCAD users around the world.

DataCAD

Software for Architects Since 1984