Ask questions about DataCAD 20, DataCAD LT 20, or previous versions here.
#71037 by MichaelB
Tue Mar 21, 2017 1:35 am
When I use SPB-Fill for color filling, I check the "no outline" box under the "Hatching" and "Solid Fill" menus.

And when I insert the color fill, there are no outlines shown which is fine.

But when I delete the fill thereafter, there is an outline overlaying the boundaries of the area previously filled.

To which setting do I refer for this outline not to be shown - as I have to manually delete them which takes time and is a hassle?

And this does not happen when I delete hatching patterns to fill within boundaries.

Help will be appreciated - Many thanks - MichaelB
#71041 by Mark Bell
Tue Mar 21, 2017 6:33 pm
Good to know Michael,

The method you were using was correct in that removing the fill still leaves the polyline that contained the fill and these were the outlines you saw. Deleting/Erasing the entity removes both.

Who is online

Users browsing this forum: No registered users and 79 guests

About DataCAD Forum

The DataCAD Forum is a FREE online community we provide to enhance your experience with DataCAD.

We hope you'll visit often to get answers, share ideas, and interact with other DataCAD users around the world.

DataCAD

Software for Architects Since 1984