Topic Title

Only in a certain drawing (which I have layer utilitied and created again) when I bring in an image from the template, it is reversed, mirrored, and completely screwed up. Never seen this before,.....

Greetings,

Check the Enlarge factor for the symbol -- if it is 1 then change it to 1.

Thanks. Neil... it's real "duh"!
New had that happen before in 10+ years on datacad.
another wierd thing is happening in the same drawing.... I can't object snap at the center of lines.... my settings show center point, but it won't snap. Any thoughts? thanks. jt

Hello,

The only two things I can think of: is Layer Snap on, and/or are they two "butted" lines?