Ask questions about DataCAD 17, DataCAD LT 17, or previous versions here.
#425 by peter korzaan
Mon Feb 21, 2005 9:10 am
We did most of this query, on Dbug, but I have one last question..

I take it that when you set the 3d knife to a level z height, that when it gives you a cu yd figure tht it is averaging out the fill and cut area... i.e. cut =8yds, fill =10 yds so the total that it gives you would be "Fill = 2yds"

Is this assumtion correct?

tahts for any help... p.
#426 by Mark Toce
Mon Feb 21, 2005 9:23 am
peter korzaan wrote:We did most of this query, on Dbug, but I have one last question..

I take it that when you set the 3d knife to a level z height, that when it gives you a cu yd figure tht it is averaging out the fill and cut area... i.e. cut =8yds, fill =10 yds so the total that it gives you would be "Fill = 2yds"

Is this assumtion correct?

tahts for any help... p.


At present, yes. This will be changed to show both the Cut and Fill values, rather than the difference of the two.

Who is online

Users browsing this forum: Google [Bot] and 9 guests

About DataCAD Forum

The DataCAD Forum is a FREE online community we provide to enhance your experience with DataCAD.

We hope you'll visit often to get answers, share ideas, and interact with other DataCAD users around the world.

DataCAD

Software for AEC Professionals Since 1984