Ask questions about DataCAD 20, DataCAD LT 20, or previous versions here.
#72753 by Neil Blanchard
Tue Nov 21, 2017 5:02 pm
The easiest way I can think of is to draw the ellipse with 4 arcs, and offset by the width of the stair. You can use the Geometry / Div + Dist. to divide the minimum or maximum width of the treads. This works for one arc, and then you have to draw circles by radius to segment the remaining treads.

It will be easier to draw, than it will be to build!

Who is online

Users browsing this forum: No registered users and 56 guests

About DataCAD Forum

The DataCAD Forum is a FREE online community we provide to enhance your experience with DataCAD.

We hope you'll visit often to get answers, share ideas, and interact with other DataCAD users around the world.

DataCAD

Software for Architects Since 1984