Ask questions about DataCAD 17, DataCAD LT 17, or previous versions here.
#72821 by Glenn Curran
Fri Dec 08, 2017 9:15 am
Hello everybody,
I'm still on Datacad 12 and need some help. I'm working in 2d and I imported a dwg produced in Vectorworks. The problem I have is that all of the imported lines are 3d and therefore don't respond to some of the editing commands in the Dcad 2d menu. It's slowing me up a bit (as well as my advancing years). Does anybody know of a way to simply convert the 3d lines to 2d? Grateful thanks in anticipation.

PS. Am I the only UK Datacad user?
#72824 by MtnArch
Fri Dec 08, 2017 1:16 pm
Clayton Taylor is also a UK user, though I think he's using V18.

Who is online

Users browsing this forum: No registered users and 9 guests

About DataCAD Forum

The DataCAD Forum is a FREE online community we provide to enhance your experience with DataCAD.

We hope you'll visit often to get answers, share ideas, and interact with other DataCAD users around the world.


Software for AEC Professionals Since 1984