Ask questions about DataCAD 17, DataCAD LT 17, or previous versions here.
#72828 by Richard Mauser
Mon Dec 11, 2017 6:02 pm
This is an oddity that seems to have started recently. When I replace a symbol with another one (in this instance, I made stencil sheet numbers with 'dots' hatch) and the original symbol has been enlarged, the symbol I replace it with won't have the same scaled hatch hatch pattern. Is this normal behavior?
#72837 by Richard Mauser
Tue Dec 12, 2017 12:37 pm
Sheer Genius! Thanks Neil.

Apparently when I hatched the other 'stencils' LockScale was on, but when I did that number, it was toggled off. Twitchy finger on the mouse, no doubt.
So, I learn something new today. Like most computer software ("apps" now) I am only scratching the surface.
For those that read this later, with the same question,
Go to: Hatch/HatchType/LockScale ->on

Who is online

Users browsing this forum: No registered users and 37 guests

About DataCAD Forum

The DataCAD Forum is a FREE online community we provide to enhance your experience with DataCAD.

We hope you'll visit often to get answers, share ideas, and interact with other DataCAD users around the world.


Software for AEC Professionals Since 1984