Ask questions about DataCAD 16, DataCAD LT 16, or previous versions here.
#73235 by bchrd
Fri Feb 09, 2018 2:13 pm

Is there a way to make a covered ellipse to get a 3d object for a model in the 2d menu using polylines? I can make a cirlce there no problem and was hoping I could use the Enlarge tool to "squeeze" down the Y dimension so not equal to the X from my covered polyline circle and create an ellipse.

That concept works in the 3d menu but the perimeter is very segmented and not smooth like it is with a covered 2d polyline.

Maybe there is a trick. Thank you.

Who is online

Users browsing this forum: No registered users and 10 guests

About DataCAD Forum

The DataCAD Forum is a FREE online community we provide to enhance your experience with DataCAD.

We hope you'll visit often to get answers, share ideas, and interact with other DataCAD users around the world.


Software for AEC Professionals Since 1984