Ask questions about DataCAD 17, DataCAD LT 17, or previous versions here.
#73764 by Jim Scott
Wed Apr 25, 2018 6:40 pm
In the prior versions of DCAD I was thinking that identify also gave line lengths. Also was thinking that after a point was set that moving the cursor gave a running length from that point as well as
x-y coordinates. Am I dreaming or is this just wishful thinking?

Who is online

Users browsing this forum: No registered users and 3 guests

About DataCAD Forum

The DataCAD Forum is a FREE online community we provide to enhance your experience with DataCAD.

We hope you'll visit often to get answers, share ideas, and interact with other DataCAD users around the world.

DataCAD

Software for AEC Professionals Since 1984