Hello Mark,
Perhaps this table could be improved with some informations.
While the 'built-in' codes (
http://www.datacad.com/ddn/built-in_fun ... umbers.htm) can be used directely into the toolbars or keyboard macros, the "ASCII" codes above pointed must be used with its 'graphic sign', which is produced after typing "Alt+number on table".
And the table above (
http://www.datacad.com/ddn/extended_character_codes.htm) could be updated displaying the complete number of characters that are 'four'. This way the code ASCII 31 would be actually ØØ31, and so on, until Ø253.
Hope this can help in some way.
Thanks,
Miguel