Ask questions about DataCAD 17, DataCAD LT 17, or previous versions here.
#74264 by Mark Bell
Thu Jul 05, 2018 5:50 am
1. Have you checked you're not in a parallel view mode instead of ortho mode? - check in the projection pad (4 heads for the elevations etc. and pick the plan view icon in the centre, then zoom extents,
2. Check clipcube isn't on,
3. Identify the length of the line - it might be thousands of Km (miles) long making the plan so small against the line, if so delete it and zoom extents,
#74295 by Mark Bell
Sun Jul 08, 2018 5:47 pm
The only other thing I can suggest is to do a file/drawing purge and see if it's corrected in the new drawing. Alternatively, copy and paste the info into a new blank drawing and test that.
#74297 by MtnArch
Mon Jul 09, 2018 12:02 am
Frank - maybe send it to one or two of us, or post it here for us to check it out?

Who is online

Users browsing this forum: No registered users and 17 guests

About DataCAD Forum

The DataCAD Forum is a FREE online community we provide to enhance your experience with DataCAD.

We hope you'll visit often to get answers, share ideas, and interact with other DataCAD users around the world.


Software for AEC Professionals Since 1984