forum.datacad.com

Hi there.
I am new with v20.
When I tried the DCAD_AEC macro I got a internal diagnostics fault 1001, error from 736 and closed the programme.
I haven't tried other macros yet, so I don't know if this is an isolated case.
How can this be fixed?
Can someone help, please.
John

I just tried it on my box and no issues or errors.

Sorry I'm not much help.

I received an INTERNAL DIAGNOSTIC FAULT 10, ERROR FROM: 736 message when closing out. I can save to another name but then the same error pops up. So I close out and say NO to save changes. My changes were saved. Is this a bug issue??
Thanks,
Gene