Page 1 of 1

Clipping from V14 to V17

PostPosted: Tue Jan 22, 2019 11:39 pm
by RBCA
Trying to clip pieces of rrawing on version 14 and inserting them into 17. When I inserted it in, it came in enlarged and mirrored. Each time I do it I have to edit settings. Is there a master setting.

Re: Clipping from V14 to V17

PostPosted: Wed Jan 23, 2019 2:58 am
by joshhuggins
I would not take clipbooks from one version to another. Open the files in v17 and copy and paste there.

Re: Clipping from V14 to V17

PostPosted: Wed Jan 23, 2019 11:12 pm
by RBCA
Thanks. I was hoping I could do it. Wanted to have a file open on each monitor and cut n paste from one to the other.

Re: Clipping from V14 to V17

PostPosted: Thu Jan 24, 2019 7:55 am
by Neil Blanchard
If you extend the DataCAD 17 window across both monitors, you can tile the two drawings within that.