forum.datacad.com

So, I'm having an issue with the Hatch Pattern Manager. Each time I change the Angle to say 45 deg... it changes to an odd angle. Why wont DC accept my input for this?

Thanks!

In fact, it also seems to happen any time I click out of the box. Regardless of what I input (and even if I dont input anything.) I click in the angle box... and immediately click out... the angle changes to a new odd ball angle.

I'd meant to cut and paste some of the angles here as examples... but DC wont let me Ctrl+C out of the dialog box either... (Why is that? Shouldnt Ctrl+C be basic code for any modern computer program?)

0 is the only number that wont change to something else.

Lars wrote:. . .Each time I change the Angle to say 45 deg . . . it changes to an odd angle. . . . . I click in the angle box... and immediately click out... the angle changes to a new odd ball angle.

Hmmm I can't seem to duplicate this, as I can input 45 into the box and it changes the angle to 45 fine. No issues left clicking out or using the buttons. Anyone else having an issue?

Lars wrote:but DC wont let me Ctrl+C out of the dialog box either

I can confirm this. How are you typing in 45? i just input "45" without the quotes.

can I attach a movie file to show the issue? .mov doesnt seem to work?

I don't think MOV is supported and there is a 3MB or so file size limit for post attachments. I usually toss it up on my website or upload to Youtube and then post it using the bbcode for a Youtube video. Here is an example where ZXRfnIfFYFI is the videos's ID.