Tangents or DirDist Bug
Posted: Thu Sep 15, 2005 10:44 pm
I'm not sure which is at fault, but most likely, it is Dirdis.
There is a bug in DataCAD 11.08 using Tangents (B or b) and DirDist (with Ortho on) to Move, Copy, or Stretch an entity in relation to itself. This is not the way it worked previously in 11 nor in v10 nor LTv11.07.
When the entity is moved, copied, or stretched the specified distance perpendicularly (sic), the specified distance result is orthographic. I couldn't figure out what was happening when moving, coping, or stretching parallel. The workaround is to use offset until this is fixed (I don't know of a workaround for stretching). See illustration below.
Illustration removed due to See post below.
There is a bug in DataCAD 11.08 using Tangents (B or b) and DirDist (with Ortho on) to Move, Copy, or Stretch an entity in relation to itself. This is not the way it worked previously in 11 nor in v10 nor LTv11.07.
When the entity is moved, copied, or stretched the specified distance perpendicularly (sic), the specified distance result is orthographic. I couldn't figure out what was happening when moving, coping, or stretching parallel. The workaround is to use offset until this is fixed (I don't know of a workaround for stretching). See illustration below.
Illustration removed due to See post below.