Ask questions about DataCAD 17, DataCAD LT 17, or previous versions here.
#79105 by kevinw
Wed Nov 25, 2020 5:16 pm
I installed 16 on a new computer and now whenever my cursor hovers over a line or entity in a drawing, an asterisk and note pop up showing the possible snap points.
I can seem to turn this off unless I turn off snapping completely. Is there a toggle somewhere to turn off that "feature"?
Thank you.
#79107 by joshhuggins
Thu Nov 26, 2020 2:40 am
It should be in the Program Preferences. It might be in a slightly different location in v16, but on v22 it's located on the Drawing tab under Dynamic Snapping. You can uncheck the indicator (asterisk) as well as the popup hint.
2020-11-25_233910.jpg (329.26 KiB) Viewed 787 times

Who is online

Users browsing this forum: No registered users and 27 guests

About DataCAD Forum

The DataCAD Forum is a FREE online community we provide to enhance your experience with DataCAD.

We hope you'll visit often to get answers, share ideas, and interact with other DataCAD users around the world.


Software for Architects Since 1984