I RECENTLY UPGRADED TO VERSION 11. I NOTICED WHEN OPENING A DC5 FILE FROM VER10 THAT IF I WENT TO PRINT A PAGE FROM THE DRAWING THAT HAD A MULTI-LAYOUT SAVED ON IT, ALL THE DRAWINGS ON THAT SHEET ARE ALL JUMBLED. DO I HAVE TO REDO ALL THE MULTI-LAYOUT DRAWINGS ON EVERY SHEET FOR EVERY PLAN I HAVE ?
Hello & Welcome:
Did you check the set up to make sure that the paper size in v11 was set to the same as it was in v10? If not, once you change this, the sheets should be correct -- you may have to exit the Plotter menu and then reopen it after making the change.
So no, you should not have to fix all the MSP sheets when moving to v11.
PS: THERE IS NO NEED TO SHOUT!