Ask questions about DataCAD 17, DataCAD LT 17, or previous versions here.
#642 by RVELAS2000
Sat Feb 26, 2005 10:50 am
I've encountered a new problem. I set up a new default drawing with the newest version of dcad 11. After I zoom in on a drawing then use the drawing extents key, some of my setings change such as the grid converts back to a 4"x4" even though I had changed it to 1/2"x1/2". Also the grids come back on even though I had turned them off.
Any answers out there...... :(
#643 by Daniel Kaczor
Sat Feb 26, 2005 7:42 pm
Did you change layers at some time? Layers can have different grid & snap settings. Use the Gridlock macro to set all the same. Macro is free from DataCAD.com.

Who is online

Users browsing this forum: No registered users and 7 guests

About DataCAD Forum

The DataCAD Forum is a FREE online community we provide to enhance your experience with DataCAD.

We hope you'll visit often to get answers, share ideas, and interact with other DataCAD users around the world.

DataCAD

Software for AEC Professionals Since 1984