Page 1 of 1

screen refresh

PostPosted: Sat Feb 26, 2005 10:50 am
by RVELAS2000
I've encountered a new problem. I set up a new default drawing with the newest version of dcad 11. After I zoom in on a drawing then use the drawing extents key, some of my setings change such as the grid converts back to a 4"x4" even though I had changed it to 1/2"x1/2". Also the grids come back on even though I had turned them off.
Any answers out there...... :(

PostPosted: Sat Feb 26, 2005 7:42 pm
by Daniel Kaczor
Did you change layers at some time? Layers can have different grid & snap settings. Use the Gridlock macro to set all the same. Macro is free from DataCAD.com.