Page 1 of 2
Changing short key function
Posted:
Tue Jul 04, 2006 10:25 amby GuyS
I use the "move" function a lot. By pressing the "m" key on the keyboard I don't have to use the mouse therefore much faster. Problem is if the caps function is turned on the "M" key now takes me to the macro function. I know that I can shift M back to m but I would prefer if the key were dedicated to the move function only. Is there a way of doing this?
Posted:
Tue Jul 04, 2006 1:15 pmby Miguel Palaoro
Posted:
Tue Jul 04, 2006 1:37 pmby GuyS
Posted:
Wed Jul 05, 2006 9:49 amby devinder
Excel sheet is also available to help you at DataCAD resource page.
Locate Miscellaneous Tools section for details.
Posted:
Wed Jul 05, 2006 10:44 amby Dick Eades
Hold on a second, Miguel. In v11 we have the ability to input distances directly without first pressing the spacebar. If you replace a key command with the number 7, what happens if you want to input a distance without the spacebar and that distance begins with 7?
V 10 and the move command
Posted:
Wed Jul 05, 2006 10:54 amby GuyS
The version I am using is V10. I looked at the /SUP folder and could not find the file or code Miguel is talking about. Perhaps Miguel your instructions are for V11 and above?
Posted:
Wed Jul 05, 2006 11:15 amby joshhuggins
Move key shortcut
Posted:
Wed Jul 05, 2006 12:58 pmby GuyS
Posted:
Wed Jul 05, 2006 1:18 pmby Tony Blasio
Posted:
Wed Jul 05, 2006 5:00 pmby Dick Eades
Posted:
Wed Jul 05, 2006 6:21 pmby joshhuggins
Success!
Posted:
Thu Jul 06, 2006 9:34 amby GuyS
Ah ha!
I found the line of code...thanks Josh. and I made the changes...thanks Miguel. And all others for persisting.
Posted:
Thu Jul 06, 2006 11:29 amby Neil Blanchard
Move command
Posted:
Thu Jul 06, 2006 11:34 amby GuyS
Move command
Posted:
Thu Jul 06, 2006 11:37 amby GuyS