Ask questions about DataCAD 17, DataCAD LT 17, or previous versions here.
#952 by KIWIGULL05
Sun Mar 13, 2005 10:09 pm
I must be getting old because I can't remember how to draw voids in slabs
I have drawn the primary slab and done as the manual says but I get "0 entities selected" when trying to apply the void. Can somebody help this old feller!!

Mike :?:
#953 by Graeme
Mon Mar 14, 2005 1:48 am
To apply a void to a slab you need to make another slab in the position you want the void. Making sure the smaller slab is the same thickness as the main slab & at the same height in elevation. Then click "voids" in the slab menu, click the main slab first then the smaller slab (the one the size and position of your void). Then right click out... You should have it

Hope you manage to figure it out, if not maybe I can explain a little different. Good Luck.
#955 by KIWIGULL05
Mon Mar 14, 2005 4:02 am
Hi Graeme

Thanks for your response-I have it sussed again. I must learn to read the manual properly-Glad you guys are out there!!
Mike :P

Who is online

Users browsing this forum: No registered users and 11 guests

About DataCAD Forum

The DataCAD Forum is a FREE online community we provide to enhance your experience with DataCAD.

We hope you'll visit often to get answers, share ideas, and interact with other DataCAD users around the world.


Software for AEC Professionals Since 1984