forum.datacad.com

Hi
I must be getting old because I can't remember how to draw voids in slabs
I have drawn the primary slab and done as the manual says but I get "0 entities selected" when trying to apply the void. Can somebody help this old feller!!

Mike

To apply a void to a slab you need to make another slab in the position you want the void. Making sure the smaller slab is the same thickness as the main slab & at the same height in elevation. Then click "voids" in the slab menu, click the main slab first then the smaller slab (the one the size and position of your void). Then right click out... You should have it

Hope you manage to figure it out, if not maybe I can explain a little different. Good Luck.

Hi Graeme

Thanks for your response-I have it sussed again. I must learn to read the manual properly-Glad you guys are out there!!
Mike