Page 1 of 1
how to actvate middle mouse button?
Posted:
Mon Aug 21, 2006 9:33 am
by STEVESCHWARTZ
My middle mouse button will not snap to any entity (have selected from Object snap menu). I have gone to the control panel to set up the mouse, but cannot find the (alternate menu setting) as shown in reefrence manual. I am using microsoft wheel mouse optical.
Thanks, steve schwartz
Posted:
Mon Aug 21, 2006 9:42 am
by Martell
Hello Steve,
Look here:
http://forum.datacad.com/viewtopic.php? ... t=logitech
It´s the Logitech mice driver. You must configure it in the software.
Posted: Fri Dec 02, 2005 6:41 pm Post subject: Middle snap wheel
--------------------------------------------------------------------------------
OK, I got it. On the MX610 there is a scroll and a left and right scroll in the SnapPoint setup. you have to set all three as middle button under other to get it to work in DataCAD.
Martell
Posted:
Mon Aug 21, 2006 11:12 am
by Neil Blanchard
Greetings Steve & welcome!
Do you have a Logitech mouse, or a Microsoft mouse, or some other brand? If it is a Logitech, then as Martell says, set the scroll wheel/middle button to Middle Button.
microsoft mouse wheel mouse optical
Posted:
Mon Aug 21, 2006 11:19 am
by STEVESCHWARTZ
My mouse has lost the ability to snap on a entity using the middle wheel button. The old mouse worked fine. Went to control panel-mouse and select the correct mouse, but the option for the wheel button does not list
for alternate menu (per Reference Manual)
Thanks, Steve
Posted:
Mon Aug 21, 2006 2:28 pm
by Martell
Oh, I had read Logitech not Microsoft mouse.
Sorry.
Martell