forum.datacad.com

Posted: **Wed Mar 16, 2005 6:23 pm**

Question:

Wasn't there a fix made a while back (v10?) that corrected the problem with the hardwired "Dashed" linetype lop-side spacing?

I noticed that my v11.05.02 "Dashed" lines don't have this problem corrected.

Posted: **Wed Mar 16, 2005 7:57 pm**

I don't remember a fix for this coming out before. I too still have the lopsided dashes on all of that linetype.

Posted: **Wed Mar 16, 2005 8:08 pm**

see C:\Program Files\DataCAD\RevHist.htm

New features in version 11.01.00

Other Enhancements

07. DataCAD's built-in Dashed line type definition has been updated so that each segment begins and ends with a solid line.

Posted: **Wed Mar 16, 2005 8:10 pm**

Hi Stuart:

It has "slipped back" a bit -- if you look very closely, there is usually a little bit of a dash there. I feel these needs to be tweaked -- the end dashes need to be no less than 33-50% of the "full" dashes. Currently, it can have a bit of a dash at one end that is vertually invisible...

Posted: **Mon Mar 21, 2005 12:27 pm**

yes, that would be a nice fix...

forum.datacad.com

Smart "Dashed" Linetype

Smart "Dashed" Linetype