Ask questions about DataCAD 15, DataCAD LT 15, or previous versions here.
#14892 by spinfox
Thu Nov 09, 2006 11:59 pm
Hi .
Can anyone can tell me if lines or poligons if its stretches to lenght=0 can be harm to your draw file healt? ( Internal diagnostic fault) .

lets put some example: lets say I wish to make a void (door) on a vertical poligon (wall) but the bottom of void its the same of the poligon, can this action will mess your draw?

in other instance.
I notice some day when I made voids in vertical poligon but when I use front view then I use horizontal poligon to make a void, but when I render it some strange triangles appears, can someone explain what happend?

thanks in advance.

Who is online

Users browsing this forum: No registered users and 4 guests

About DataCAD Forum

The DataCAD Forum is a FREE online community we provide to enhance your experience with DataCAD.

We hope you'll visit often to get answers, share ideas, and interact with other DataCAD users around the world.

DataCAD

Software for AEC Professionals Since 1984