Ask questions about DataCAD 20, DataCAD LT 20, or previous versions here.
#15098 by peter korzaan
Tue Nov 14, 2006 1:54 pm
I've done the normal modeling of leveling and indenting a tin model, but have no clue on how you can cut say an area, shaped like a pie at a slope from 0z to -4'z at its widest point.

Point me in the right direction please.. p.

Who is online

Users browsing this forum: No registered users and 22 guests

About DataCAD Forum

The DataCAD Forum is a FREE online community we provide to enhance your experience with DataCAD.

We hope you'll visit often to get answers, share ideas, and interact with other DataCAD users around the world.

DataCAD

Software for Architects Since 1984